New Product Release
The resistors are constructed in a ceramic based (aluminum oxide). Long-side termination (reverse-geometry) type flat chip resistor, robust design is major concern, provide a shorter path for heat dissipation to the PCB, enhance high power rating, Wide electrode construction supports good thermal cycling performance. The composition of the paste is adjusted to give the approximate resistance required and is trimmed to nominated value by laser trimmer.Read More
Anti-Surfur resistor is using high sulfuration-proof inner electrode material and special construction of termination to increase the strength to against the sulfuration. Sulfuration occurs in the resistor with silver for inner electrode. Sulfurated environment is included as sulfur gas near hot spring or volcanos or produced through firing of raw oil, even outdoor equipment under air pollution could be affected. Silver sulfide produced through this reaction impacts the conductivity therefore resistor gets disconnected.Viking ‘s Anti-sulfurated resistors are an ideal choice to prevent your electronic devices being damaged from the high –sulfur environment.Product applications：automotive electronic components, power supplies, industrial equipment, petrochemical industry electronic equipment, network servers, sulfur detectors, telecom stations, sewage treatment facilities, etc.Read More
Chip Resistor Array (R Network) is single packaged device containing an array of homogeneous resistor elements. Resistor array is typically used for convenience and cost or space saving when several same resistors applied in a layout. The size can be as small as 0201,4P2R or 8P4R. AS43,AS42,AS41,AS21 Resistor Arry is using special construction of termination to increase the strength to against the sulfuration. Silver sulfide produced due to high Sulfur environment that impacts the conductivity, therefore resistor gets disconnected. Viking ‘s Anti-sulfurated resistor array is an ideal choice to prevent your electronic devices being damaged from the high –sulfur environment.Read More
ARN Series Chip resistors are designed on high thermal conductivity Aluminum Nitride substrate with enlarged backside terminations to reduce the thermal resistance. As with any high power chip resistor has good ability to remove the heat to the overall performance of the devices. Aluminum Nitride Precision Thin Film Chip Resistor-ARN Series ● High thermal conductivity aluminum nitride substrate ● High-power resistors 1206 up to 2 watts, 2512 6W soon is coming ● Offer 2x the power rating over traditional thin-film chip resistors ● Designed with enlarged backside terminations to reduce the thermal resistance ● Low TC down to 25 ppm/C ,Tight tolerance to 0.1% Please consult with us for the new product.Read More
Metal Foil is special designed for 4 terminations, Kelvin design , surface-mount ,High power and Tight Tolerance of 0.5% for critical current sensing design. This resistor covers the most widely used resistance range from 10m~20m. This technology offers an excellent Temperature Coefficient of Resistance (TCR) and high reliable, accurate current detection. Four Terminal High Precision Current Sense Resistors-4T SeriesRead More
New product-LRP series High power Metal strip current sensingResistance Range: R010~R100 High power 2512 3W, 1206 1W Low TC 50-75ppm/C High Temp to 170C Tight Tolerance to 0.5%Read More
- About Viking
- RF Ceramic Inductor
- Ferrite Chip Inductor
- Miniature Power Inductor
- Power Choke Power Inductor
- SMD Metal Alloy Power Inductor
- Shielding Power Inductor
- Non-Shielding Power Inductor
- Wire Wound Power Inductor
- DIP Power Inductor
- EMI Bead (CBM Series)
- Common Mode Filter (CM Series)
- Automotive Grade Inductor
Precision Resistor | RF Inductor Manufacturer - Viking
Based in Taiwan, Viking Tech Corporation, since 1997, is an ultra-precision resistor manufacturer. And their products are used throughout automotive, electronic device applications, with manufacturing tolerance down to 0.01% and TCR down to 2 ppm in a broad range of package sizes.
TS16949/ ISO9001/ ISO14001 and meet AEC-Q200 standards, Viking has been offering anti-sulfur, anti-surge, pulse, high voltage, high power precision resistors including thin/ thick film resistors, automotive resistors, melf resistors, current sense resistors, etc. Low noise, low TC, high power inductors such as rf inductors, chip inductors, power inductors, variable inductors, ferrite chip inductors, shielded inductors, wire wound inductors and dip inductors.
Viking has been offering customers high quality power resistors, power inductors and aluminum electrolytic capacitors with solid reputation. Both with advanced technology and 20 years of experience, Viking makes sure to meet each customer's demands.